Komatsu Wa250-1Lc Wheel Loader Service Manual
GENERAL PRECAUTIONS
Mistakes in operation are extremely dangerous. Read the Operation and Maintenance Manual carefully BEFORE operating the machine.
Before carrying out any greasing or repairs, read all the precautions given on the decals which are fixed to the machine.
When carrying out any operation, always wear safety shoes and helmet. Do not wear loose work clothes, or clothes with buttons missing.
-Always wear safety glasses when hitting parts with a hammer.
-Always wear safety glasses when grinding parts with a grinder, etc. If welding repairs are needed, always have a trained, experienced welder carry out the work.
When carrying out welding work, always wear welding gloves, an apron, glasses, cap, and other clothes suited for welding work.
When carrying out any operation with two or more workers, always agree on the operating procedure before starting. Always inform your fellow workers before starting any step of the operation.
Before starting work, hang UNDER REPAIR signs on the controls in the operator’s compartment. Keep all tools in good condition and learn the correct way to use them.
Komatsu Wa250-1Lc Wheel Loader Service Manual
Manual Table of Content:
- Contents
- Engine
- Power Train
- Steering System
- Brake and Air System
- Work Equipment
- Electric and Electronic System
- Others
Decide a place in the repair workshop to keep tools and removed parts. Always keep the tools and parts in their correct places. Always keep the work area clean and make sure that there is no dirt or oil on the floor. Smoke only in the areas provided for smoking. Never smoke while working.
Maintenance
Engine
Control System
Mechanical
Fuel Service Specifications
Emission Control
Intake Exhaust Cooling
Lube
Ignition Starting Charging
Auto Transmission Clutch
Manual Transmission
Transfer Propeller Shaft
Drive Shaft
Differential
Axle Suspension
Tire & Wheel
Brake Control
Brake
Parking Brake
Steering Column
Power Steering
Air Condition
Restraint System
Seat Belt
Engine Immobilizer
Cruise Control
Wiper & Washer
Door Lock
Meter Audio/Visual
Horn
Windshield/Glass Mirror
Instrument Panel
Seat
Engine Hood/ Door
Exterior & Interior
Electrical
Multiplex/ Can Communication
And much more…
PREPARATIONS FOR WORK
Before adding oil or making repairs, park the machine on hard, level ground, and block the wheels or tracks to prevent the machine from
moving.
Before starting work, lower blade, ripper, bucket, or any other work equipment to the ground. If this is not possible, insert the safety pin or use blocks to prevent the work equipment from falling. In addition, be sure to lock all the control levers and hang warning signs on them.
When disassembling or assembling, support the machine with blocks, jacks or stands before starting work.
Remove all mud and oil from the steps or other places used to get on and off the machine. Always use the handrails, ladders, or steps when getting on or off the machine. Never jump on or off the machine. If it is impossible to use the handrails, ladders, or steps, use a stand to provide safe footing.
